/*
 *  pata_piccolo.c - Toshiba Piccolo PATA/SATA controller driver.
 *
 *  This is basically an update to ata_generic.c to add Toshiba Piccolo support
 *  then split out to keep ata_generic "clean".
 *
 *  Copyright 2005 Red Hat Inc, all rights reserved.
 *
 *  Elements from ide/pci/generic.c
 *	    Copyright (C) 2001-2002	Andre Hedrick <andre@linux-ide.org>
 *	    Portions (C) Copyright 2002  Red Hat Inc <alan@redhat.com>
 *
 *  May be copied or modified under the terms of the GNU General Public License
 *
 *  The timing data tables/programming info are courtesy of the NetBSD driver
 */

#include <linux/kernel.h>
#include <linux/module.h>
#include <linux/pci.h>
#include <linux/blkdev.h>
#include <linux/delay.h>
#include <scsi/scsi_host.h>
#include <linux/libata.h>

#define DRV_NAME "pata_piccolo"
#define DRV_VERSION "0.0.1"



static void tosh_set_piomode(struct ata_port *ap, struct ata_device *adev)
{
	static const u16 pio[6] = {	/* For reg 0x50 low word & E088 */
		0x0566, 0x0433, 0x0311, 0x0201, 0x0200, 0x0100
	};
	struct pci_dev *pdev = to_pci_dev(ap->host->dev);
	u16 conf;
	pci_read_config_word(pdev, 0x50, &conf);
	conf &= 0xE088;
	conf |= pio[adev->pio_mode - XFER_PIO_0];
	pci_write_config_word(pdev, 0x50, conf);
}

static void tosh_set_dmamode(struct ata_port *ap, struct ata_device *adev)
{
	struct pci_dev *pdev = to_pci_dev(ap->host->dev);
	u32 conf;
	pci_read_config_dword(pdev, 0x5C, &conf);
	conf &= 0x78FFE088;	/* Keep the other bits */
	if (adev->dma_mode >= XFER_UDMA_0) {
		int udma = adev->dma_mode - XFER_UDMA_0;
		conf |= 0x80000000;
		conf |= (udma + 2) << 28;
		conf |= (2 - udma) * 0x111;	/* spread into three nibbles */
	} else {
		static const u32 mwdma[4] = {
			0x0655, 0x0200, 0x0200, 0x0100
		};
		conf |= mwdma[adev->dma_mode - XFER_MW_DMA_0];
	}
	pci_write_config_dword(pdev, 0x5C, conf);
}


static const struct scsi_host_template tosh_sht = {
	ATA_BMDMA_SHT(DRV_NAME),
};

static struct ata_port_operations tosh_port_ops = {
	.inherits	= &ata_bmdma_port_ops,
	.cable_detect	= ata_cable_unknown,
	.set_piomode	= tosh_set_piomode,
	.set_dmamode	= tosh_set_dmamode
};

/**
 *	ata_tosh_init_one		-	attach generic IDE
 *	@dev: PCI device found
 *	@id: match entry
 *
 *	Called each time a matching IDE interface is found. We check if the
 *	interface is one we wish to claim and if so we perform any chip
 *	specific hacks then let the ATA layer do the heavy lifting.
 */

static int ata_tosh_init_one(struct pci_dev *dev, const struct pci_device_id *id)
{
	static const struct ata_port_info info = {
		.flags = ATA_FLAG_SLAVE_POSS,
		.pio_mask = ATA_PIO5,
		.mwdma_mask = ATA_MWDMA2,
		.udma_mask = ATA_UDMA2,
		.port_ops = &tosh_port_ops
	};
	const struct ata_port_info *ppi[] = { &info, &ata_dummy_port_info };
	/* Just one port for the moment */
	return ata_pci_bmdma_init_one(dev, ppi, &tosh_sht, NULL, 0);
}

static struct pci_device_id ata_tosh[] = {
	{ PCI_DEVICE(PCI_VENDOR_ID_TOSHIBA,PCI_DEVICE_ID_TOSHIBA_PICCOLO_1), },
	{ PCI_DEVICE(PCI_VENDOR_ID_TOSHIBA,PCI_DEVICE_ID_TOSHIBA_PICCOLO_2),  },
	{ PCI_DEVICE(PCI_VENDOR_ID_TOSHIBA,PCI_DEVICE_ID_TOSHIBA_PICCOLO_3),  },
	{ PCI_DEVICE(PCI_VENDOR_ID_TOSHIBA,PCI_DEVICE_ID_TOSHIBA_PICCOLO_5),  },
	{ 0, },
};

static struct pci_driver ata_tosh_pci_driver = {
	.name 		= DRV_NAME,
	.id_table	= ata_tosh,
	.probe 		= ata_tosh_init_one,
	.remove		= ata_pci_remove_one,
#ifdef CONFIG_PM_SLEEP
	.suspend	= ata_pci_device_suspend,
	.resume		= ata_pci_device_resume,
#endif
};

module_pci_driver(ata_tosh_pci_driver);

MODULE_AUTHOR("Alan Cox");
MODULE_DESCRIPTION("Low level driver for Toshiba Piccolo ATA");
MODULE_LICENSE("GPL");
MODULE_DEVICE_TABLE(pci, ata_tosh);
MODULE_VERSION(DRV_VERSION