Linux v6.6.1 - wil6210

# SPDX-License-Identifier: ISC
config WIL6210
	tristate "Wilocity 60g WiFi card wil6210 support"
	select WANT_DEV_COREDUMP
	select CRC32
	depends on CFG80211
	depends on PCI
	default n
	help
	  This module adds support for wireless adapter based on
	  wil6210 chip by Wilocity. It supports operation on the
	  60 GHz band, covered by the IEEE802.11ad standard.

	  https://wireless.wiki.kernel.org/en/users/Drivers/wil6210

	  If you choose to build it as a module, it will be called
	  wil6210

config WIL6210_ISR_COR
	bool "Use Clear-On-Read mode for ISR registers for wil6210"
	depends on WIL6210
	default y
	help
	  ISR registers on wil6210 chip may operate in either
	  COR (Clear-On-Read) or W1C (Write-1-to-Clear) mode.
	  For production code, use COR (say y); is default since
	  it saves extra target transaction;
	  For ISR debug, use W1C (say n); is allows to monitor ISR
	  registers with debugfs. If COR were used, ISR would
	  self-clear when accessed for debug purposes, it makes
	  such monitoring impossible.
	  Say y unless you debug interrupts

config WIL6210_TRACING
	bool "wil6210 tracing support"
	depends on WIL6210
	depends on EVENT_TRACING
	default n
	help
	  Say Y here to enable tracepoints for the wil6210 driver
	  using the kernel tracing infrastructure.  Select this
	  option if you are interested in debugging the driver.

	  If unsure, say Y to make it easier to debug problems.

config WIL6210_DEBUGFS
	bool "wil6210 debugfs support"
	depends on WIL6210
	depends on DEBUG_FS
	default y
	help
	  Say Y here to enable wil6210 debugfs support, using the
	  kernel debugfs infrastructure. Select this
	  option if you are interested in debugging the driver.

	  If unsure, say Y to make it easier to debug problems.