// SPDX-License-Identifier: GPL-2.0 #include <dt-bindings/iio/qcom,spmi-vadc.h> #include <dt-bindings/interrupt-controller/irq.h> #include <dt-bindings/spmi/spmi.h> / { thermal-zones { pm8941-thermal { polling-delay-passive = <100>; polling-delay = <0>; thermal-sensors = <&pm8941_temp>; trips { trip0 { temperature = <105000>; hysteresis = <2000>; type = "passive"; }; trip1 { temperature = <125000>; hysteresis = <2000>; type = "hot"; }; crit { temperature = <145000>; hysteresis = <2000>; type = "critical"; }; }; }; }; }; &spmi_bus { pm8941_0: pm8941@0 { compatible = "qcom,pm8941", "qcom,spmi-pmic"; reg = <0x0 SPMI_USID>; #address-cells = <1>; #size-cells = <0>; rtc@6000 { compatible = "qcom,pm8941-rtc"; reg = <0x6000>, <0x6100>; reg-names = "rtc", "alarm"; interrupts = <0x0 0x61 0x1 IRQ_TYPE_EDGE_RISING>; }; pon@800 { compatible = "qcom,pm8941-pon"; reg = <0x800>; pwrkey { compatible = "qcom,pm8941-pwrkey"; interrupts = <0x0 0x8 0 IRQ_TYPE_EDGE_BOTH>; debounce = <15625>; bias-pull-up; }; pm8941_resin: resin { compatible = "qcom,pm8941-resin"; interrupts = <0x0 0x8 1 IRQ_TYPE_EDGE_BOTH>; debounce = <15625>; bias-pull-up; status = "disabled"; }; }; usb_id: usb-detect@900 { compatible = "qcom,pm8941-misc"; reg = <0x900>; interrupts = <0x0 0x9 0 IRQ_TYPE_EDGE_BOTH>; interrupt-names = "usb_id"; }; smbb: charger@1000 { compatible = "qcom,pm8941-charger"; reg = <0x1000>; interrupts = <0x0 0x10 7 IRQ_TYPE_EDGE_BOTH>, <0x0 0x10 5 IRQ_TYPE_EDGE_BOTH>, <0x0 0x10 4 IRQ_TYPE_EDGE_BOTH>, <0x0 0x12 1 IRQ_TYPE_EDGE_BOTH>, <0x0 0x12 0 IRQ_TYPE_EDGE_BOTH>, <0x0 0x13 2 IRQ_TYPE_EDGE_BOTH>, <0x0 0x13 1 IRQ_TYPE_EDGE_BOTH>, <0x0 0x14 1 IRQ_TYPE_EDGE_BOTH>; interrupt-names = "chg-done", "chg-fast", "chg-trkl", "bat-temp-ok", "bat-present", "chg-gone", "usb-valid", "dc-valid"; usb-otg-in-supply = <&pm8941_5vs1>; chg_otg: otg-vbus { }; }; pm8941_gpios: gpio@c000 { compatible = "qcom,pm8941-gpio", "qcom,spmi-gpio"; reg = <0xc000>; gpio-controller; gpio-ranges = <&pm8941_gpios 0 0 36>; #gpio-cells = <2>; interrupt-controller; #interrupt-cells = <2>; boost_bypass_n_pin: boost-bypass-state { pins = "gpio21"; function = "normal"; }; }; pm8941_mpps: mpps@a000 { compatible = "qcom,pm8941-mpp", "qcom,spmi-mpp"; reg = <0xa000>; gpio-controller; #gpio-cells = <2>; gpio-ranges = <&pm8941_mpps 0 0 8>; interrupt-controller; #interrupt-cells = <2>; }; pm8941_temp: temp-alarm@2400 { compatible = "qcom,spmi-temp-alarm"; reg = <0x2400>; interrupts = <0 0x24 0 IRQ_TYPE_EDGE_RISING>; io-channels = <&pm8941_vadc VADC_DIE_TEMP>; io-channel-names = "thermal"; #thermal-sensor-cells = <0>; }; pm8941_vadc: adc@3100 { compatible = "qcom,spmi-vadc"; reg = <0x3100>; interrupts = <0x0 0x31 0x0 IRQ_TYPE_EDGE_RISING>; #address-cells = <1>; #size-cells = <0>; #io-channel-cells = <1>; channel@6 { reg = <VADC_VBAT_SNS>; }; channel@8 { reg = <VADC_DIE_TEMP>; }; channel@9 { reg = <VADC_REF_625MV>; }; channel@a { reg = <VADC_REF_1250MV>; }; channel@e { reg = <VADC_GND_REF>; }; channel@f { reg = <VADC_VDD_VADC>; }; channel@30 { reg = <VADC_LR_MUX1_BAT_THERM>; }; }; pm8941_iadc: adc@3600 { compatible = "qcom,pm8941-iadc", "qcom,spmi-iadc"; reg = <0x3600>; interrupts = <0x0 0x36 0x0 IRQ_TYPE_EDGE_RISING>; qcom,external-resistor-micro-ohms = <10000>; }; pm8941_coincell: charger@2800 { compatible = "qcom,pm8941-coincell"; reg = <0x2800>; status = "disabled"; }; }; pm8941_1: pm8941@1 { compatible = "qcom,pm8941", "qcom,spmi-pmic"; reg = <0x1 SPMI_USID>; #address-cells = <1>; #size-cells = <0>; pm8941_lpg: pwm { compatible = "qcom,pm8941-lpg"; #address-cells = <1>; #size-cells = <0>; #pwm-cells = <2>; status = "disabled"; }; pm8941_vib: vibrator@c000 { compatible = "qcom,pm8916-vib"; reg = <0xc000>; status = "disabled"; }; pm8941_wled: wled@d800 { compatible = "qcom,pm8941-wled"; reg = <0xd800>; label = "backlight"; status = "disabled"; }; regulators { compatible = "qcom,pm8941-regulators"; interrupts = <0x1 0x83 0x2 0>, <0x1 0x84 0x2 0>; interrupt-names = "ocp-5vs1", "ocp-5vs2"; vin_5vs-supply = <&pm8941_5v>; pm8941_5v: s4 { regulator-min-microvolt = <5000000>; regulator-max-microvolt = <5000000>; regulator-enable-ramp-delay = <500>; }; pm8941_5vs1: 5vs1 { regulator-enable-ramp-delay = <1000>; regulator-pull-down; regulator-over-current-protection; qcom,ocp-max-retries = <10>; qcom,ocp-retry-delay = <30>; qcom,vs-soft-start-strength = <0>; regulator-initial-mode = <1>; }; pm8941_5vs2: 5vs2 { regulator-enable-ramp-delay = <1000>; regulator-pull-down; regulator-over-current-protection; qcom,ocp-max-retries = <10>; qcom,ocp-retry-delay = <30>; qcom,vs-soft-start-strength = <0>; regulator-initial-mode = <1>; }; }; }; };