// SPDX-License-Identifier: GPL-2.0-only OR MIT
/*
* Copyright (c) Toradex
*
* Toradex OSM iMX93/iMX91 SoM on OSM Development carrier board
*
* https://www.toradex.com/computer-on-modules/osm-arm-family/nxp-imx93
* https://www.toradex.com/computer-on-modules/osm-arm-family/nxp-imx91
* https://www.toradex.com/products/carrier-board/osm-development-board
*/
#include <dt-bindings/interrupt-controller/irq.h>
#include <dt-bindings/net/ti-dp83867.h>
#include <dt-bindings/usb/pd.h>
/ {
aliases {
eeprom1 = &carrier_eeprom;
};
reg_carrier_1p8v: regulator-carrier-1p8v {
compatible = "regulator-fixed";
regulator-max-microvolt = <1800000>;
regulator-min-microvolt = <1800000>;
regulator-name = "On-carrier V1.8_SW";
};
sound {
compatible = "simple-audio-card";
simple-audio-card,bitclock-master = <&codec_dai>;
simple-audio-card,format = "i2s";
simple-audio-card,frame-master = <&codec_dai>;
simple-audio-card,mclk-fs = <256>;
simple-audio-card,name = "verdin-wm8904";
simple-audio-card,routing =
"Headphone Jack", "HPOUTL",
"Headphone Jack", "HPOUTR",
"IN2L", "Line In Jack",
"IN2R", "Line In Jack",
"Microphone Jack", "MICBIAS",
"IN1L", "Microphone Jack";
simple-audio-card,widgets =
"Microphone", "Microphone Jack",
"Headphone", "Headphone Jack",
"Line", "Line In Jack";
codec_dai: simple-audio-card,codec {
sound-dai = <&wm8904_1a>;
};
simple-audio-card,cpu {
sound-dai = <&sai3>;
};
};
};
/* OSM ADC_0, ADC_1 */
&adc1 {
status = "okay";
};
/* OSM ETH_A */
&eqos {
phy-handle = <ðphy_a>;
phy-mode = "rgmii-id";
status = "okay";
};
/* OSM ETH_B */
&fec {
phy-handle = <ðphy_b>;
phy-mode = "rgmii-id";
status = "okay";
};
/* OSM CAN_A */
&flexcan1 {
status = "okay";
};
/* OSM CAN_B */
&flexcan2 {
status = "okay";
};
&gpio2 {
pinctrl-names = "default";
pinctrl-0 = <&pinctrl_gpio_a1>, <&pinctrl_gpio_a2>, <&pinctrl_gpio_a3>,
<&pinctrl_gpio_a4>, <&pinctrl_gpio_a5>;
};
&gpio4 {
pinctrl-names = "default";
pinctrl-0 = <&pinctrl_gpio_a6>;
};
/* OSM I2C_B */
&lpi2c1 {
i2c-mux@70 {
compatible = "nxp,pca9548";
reg = <0x70>;
#address-cells = <1>;
#size-cells = <0>;
i2c_csi: i2c@0 {
reg = <0>;
#address-cells = <1>;
#size-cells = <0>;
};
i2c_lvds: i2c@1 {
reg = <1>;
#address-cells = <1>;
#size-cells = <0>;
};
/* I2C on DSI connector pin #4 and #6 */
i2c_dsi_1: i2c@2 {
reg = <2>;
#address-cells = <1>;
#size-cells = <0>;
};
/* I2C on DSI connector pin #52 and #54 */
i2c_dsi_2: i2c@3 {
reg = <3>;
#address-cells = <1>;
#size-cells = <0>;
};
};
};
/* OSM I2C_A */
&lpi2c3 {
status = "okay";
wm8904_1a: audio-codec@1a {
compatible = "wlf,wm8904";
reg = <0x1a>;
pinctrl-names = "default";
pinctrl-0 = <&pinctrl_i2s_a_mclk>;
clocks = <&clk IMX93_CLK_SAI3>;
clock-names = "mclk";
#sound-dai-cells = <0>;
AVDD-supply = <®_carrier_1p8v>;
CPVDD-supply = <®_carrier_1p8v>;
DBVDD-supply = <®_carrier_1p8v>;
DCVDD-supply = <®_carrier_1p8v>;
MICVDD-supply = <®_carrier_1p8v>;
};
gpio@20 {
compatible = "nxp,pcal6408";
reg = <0x20>;
#gpio-cells = <2>;
gpio-controller;
gpio-line-names =
"PWR_CTRL_CAN_A", /* 0 */
"PWR_CTRL_CAN_B",
"PWR_CTRL_USB-HUB",
"LVDS_MUX_CTRL",
"USB_MUX_CTRL",
"I2CA_IOEXP_P5",
"I2CA_IOEXP_P6",
"I2CA_IOEXP_P7";
lvds_mux_ctrl: lvds-mux-ctrl-hog {
gpio-hog;
gpios = <3 GPIO_ACTIVE_HIGH>;
line-name = "LVDS_MUX_CTRL";
output-high;
};
usb_mux_ctrl: usb-mux-ctrl-hog {
gpio-hog;
gpios = <4 GPIO_ACTIVE_HIGH>;
line-name = "USB_MUX_CTRL";
output-low;
};
};
hwmon@40 {
compatible = "ti,ina219";
reg = <0x40>;
shunt-resistor = <10000>;
};
temperature-sensor@4f {
compatible = "ti,tmp1075";
reg = <0x4f>;
};
tcpc@52 {
compatible = "nxp,ptn5110", "tcpci";
reg = <0x52>;
pinctrl-names = "default";
pinctrl-0 = <&pinctrl_gpio_a0>;
interrupt-parent = <&gpio2>;
interrupts = <0 IRQ_TYPE_LEVEL_LOW>;
connector {
compatible = "usb-c-connector";
label = "USB_A";
data-role = "dual";
power-role = "dual";
try-power-role = "sink";
self-powered;
source-pdos = <PDO_FIXED(5000, 3000, PDO_FIXED_USB_COMM)>;
sink-pdos = <PDO_FIXED(5000, 0, PDO_FIXED_USB_COMM)>;
op-sink-microwatt = <0>;
port {
usb_c_a_conn_hs: endpoint {
remote-endpoint = <&usb_a_hs>;
};
};
};
};
carrier_eeprom: eeprom@57 {
compatible = "st,24c02", "atmel,24c02";
reg = <0x57>;
pagesize = <16>;
};
};
/* OSM SPI_B */
&lpspi1 {
status = "okay";
};
/* OSM SPI_A */
&lpspi8 {
status = "okay";
};
/* OSM UART_CON, used as the Linux Console */
&lpuart1 {
status = "okay";
};
/* OSM UART_C */
&lpuart2 {
status = "okay";
};
/* OSM UART_A */
&lpuart6 {
status = "okay";
};
/* OSM UART_B */
&lpuart7 {
status = "okay";
};
/* OSM ETH_MDIO */
&mdio {
status = "okay";
ethphy_a: ethernet-phy@2 {
reg = <2>;
pinctrl-names = "default";
pinctrl-0 = <&pinctrl_gpio_a7>;
interrupt-parent = <&gpio4>;
interrupts = <15 IRQ_TYPE_LEVEL_LOW>;
ti,rx-internal-delay = <DP83867_RGMIIDCTL_2_00_NS>;
ti,tx-internal-delay = <DP83867_RGMIIDCTL_2_00_NS>;
};
ethphy_b: ethernet-phy@3 {
reg = <3>;
ti,rx-internal-delay = <DP83867_RGMIIDCTL_2_00_NS>;
ti,tx-internal-delay = <DP83867_RGMIIDCTL_2_00_NS>;
};
};
/* OSM I2S_A */
&sai3 {
status = "okay";
};
/* OSM PWM_0 */
&tpm4 {
status = "okay";
};
/* OSM PWM_1 */
&tpm5 {
status = "okay";
};
/* OSM PWM_2 */
&tpm6 {
status = "okay";
};
/* OSM USB_A */
&usbotg1 {
status = "okay";
port {
usb_a_hs: endpoint {
remote-endpoint = <&usb_c_a_conn_hs>;
};
};
};
/* OSM USB_B */
&usbotg2 {
status = "okay";
};
/* OSM SDIO_A */
&usdhc2 {
status = "okay";
};
/* OSM SDIO_B */
&usdhc3 {
status = "okay";
};