// SPDX-License-Identifier: GPL-2.0-or-later
/*
* Copyright (C) 2000, 2001, 2002, 2003 Broadcom Corporation
*/
#include <linux/kernel.h>
#include <linux/init.h>
#include <linux/linkage.h>
#include <linux/interrupt.h>
#include <linux/spinlock.h>
#include <linux/smp.h>
#include <linux/mm.h>
#include <linux/kernel_stat.h>
#include <asm/errno.h>
#include <asm/signal.h>
#include <asm/time.h>
#include <asm/io.h>
#include <asm/sibyte/sb1250_regs.h>
#include <asm/sibyte/sb1250_int.h>
#include <asm/sibyte/sb1250_uart.h>
#include <asm/sibyte/sb1250_scd.h>
#include <asm/sibyte/sb1250.h>
/*
* These are the routines that handle all the low level interrupt stuff.
* Actions handled here are: initialization of the interrupt map, requesting of
* interrupt lines by handlers, dispatching if interrupts to handlers, probing
* for interrupt lines
*/
#ifdef CONFIG_SIBYTE_HAS_LDT
extern unsigned long ldt_eoi_space;
#endif
/* Store the CPU id (not the logical number) */
int sb1250_irq_owner[SB1250_NR_IRQS];
static DEFINE_RAW_SPINLOCK(sb1250_imr_lock);
void sb1250_mask_irq(int cpu, int irq)
{
unsigned long flags;
u64 cur_ints;
raw_spin_lock_irqsave(&sb1250_imr_lock, flags);
cur_ints = ____raw_readq(IOADDR(A_IMR_MAPPER(cpu) +
R_IMR_INTERRUPT_MASK));
cur_ints |= (((u64) 1) << irq);
____raw_writeq(cur_ints, IOADDR(A_IMR_MAPPER(cpu) +
R_IMR_INTERRUPT_MASK));
raw_spin_unlock_irqrestore(&sb1250_imr_lock, flags);
}
void sb1250_unmask_irq(int cpu, int irq)
{
unsigned long flags;
u64 cur_ints;
raw_spin_lock_irqsave(&sb1250_imr_lock, flags);
cur_ints = ____raw_readq(IOADDR(A_IMR_MAPPER(cpu) +
R_IMR_INTERRUPT_MASK));
cur_ints &= ~(((u64) 1) << irq);
____raw_writeq(cur_ints, IOADDR(A_IMR_MAPPER(cpu) +
R_IMR_INTERRUPT_MASK));
raw_spin_unlock_irqrestore(&sb1250_imr_lock, flags);
}
#ifdef CONFIG_SMP
static int sb1250_set_affinity(struct irq_data *d, const struct cpumask *mask,
bool force)
{
int i = 0, old_cpu, cpu, int_on;
unsigned int irq = d->irq;
u64 cur_ints;
unsigned long flags;
i = cpumask_first_and(mask, cpu_online_mask);
/* Convert logical CPU to physical CPU */
cpu = cpu_logical_map(i);
/* Protect against other affinity changers and IMR manipulation */
raw_spin_lock_irqsave(&sb1250_imr_lock, flags);
/* Swizzle each CPU's IMR (but leave the IP selection alone) */
old_cpu = sb1250_irq_owner[irq];
cur_ints = ____raw_readq(IOADDR(A_IMR_MAPPER(old_cpu) +
R_IMR_INTERRUPT_MASK));
int_on = !(cur_ints & (((u64) 1) << irq));
if (int_on) {
/* If it was on, mask it */
cur_ints |= (((u64) 1) << irq);
____raw_writeq(cur_ints, IOADDR(A_IMR_MAPPER(old_cpu) +
R_IMR_INTERRUPT_MASK));
}
sb1250_irq_owner[irq] = cpu;
if (int_on) {
/* unmask for the new CPU */
cur_ints = ____raw_readq(IOADDR(A_IMR_MAPPER(cpu) +
R_IMR_INTERRUPT_MASK));
cur_ints &= ~(((u64) 1) << irq);
____raw_writeq(cur_ints, IOADDR(A_IMR_MAPPER(cpu) +
R_IMR_INTERRUPT_MASK));
}
raw_spin_unlock_irqrestore(&sb1250_imr_lock, flags);
return 0;
}
#endif
static void disable_sb1250_irq(struct irq_data *d)
{
unsigned int irq = d->irq;
sb1250_mask_irq(sb1250_irq_owner[irq], irq);
}
static void enable_sb1250_irq(struct irq_data *d)
{
unsigned int irq = d->irq;
sb1250_unmask_irq(sb1250_irq_owner[irq], irq);
}
static void ack_sb1250_irq(struct irq_data *d)
{
unsigned int irq = d->irq;
#ifdef CONFIG_SIBYTE_HAS_LDT
u64 pending;
/*
* If the interrupt was an HT interrupt, now is the time to
* clear it. NOTE: we assume the HT bridge was set up to
* deliver the interrupts to all CPUs (which makes affinity
* changing easier for us)
*/
pending = __raw_readq(IOADDR(A_IMR_REGISTER(sb1250_irq_owner[irq],
R_IMR_LDT_INTERRUPT)));
pending &= ((u64)1 << (irq));
if (pending) {
int i;
for (i=0; i<NR_CPUS; i++) {
int cpu;
#ifdef CONFIG_SMP
cpu = cpu_logical_map(i);
#else
cpu = i;
#endif
/*
* Clear for all CPUs so an affinity switch
* doesn't find an old status
*/
__raw_writeq(pending,
IOADDR(A_IMR_REGISTER(cpu,
R_IMR_LDT_INTERRUPT_CLR)));
}
/*
* Generate EOI. For Pass 1 parts, EOI is a nop. For
* Pass 2, the LDT world may be edge-triggered, but
* this EOI shouldn't hurt. If they are
* level-sensitive, the EOI is required.
*/
*(uint32_t *)(ldt_eoi_space+(irq<<16)+(7<<2)) = 0;
}
#endif
sb1250_mask_irq(sb1250_irq_owner[irq], irq);
}
static struct irq_chip sb1250_irq_type = {
.name = "SB1250-IMR",
.irq_mask_ack = ack_sb1250_irq,
.irq_unmask = enable_sb1250_irq,
.irq_mask = disable_sb1250_irq,
#ifdef CONFIG_SMP
.irq_set_affinity = sb1250_set_affinity
#endif
};
void __init init_sb1250_irqs(void)
{
int i;
for (i = 0; i < SB1250_NR_IRQS; i++) {
irq_set_chip_and_handler(i, &sb1250_irq_type,
handle_level_irq);
sb1250_irq_owner[i] = 0;
}
}
/*
* arch_init_irq is called early in the boot sequence from init/main.c via
* init_IRQ. It is responsible for setting up the interrupt mapper and
* installing the handler that will be responsible for dispatching interrupts
* to the "right" place.
*/
/*
* For now, map all interrupts to IP[2]. We could save
* some cycles by parceling out system interrupts to different
* IP lines, but keep it simple for bringup. We'll also direct
* all interrupts to a single CPU; we should probably route
* PCI and LDT to one cpu and everything else to the other
* to balance the load a bit.
*
* On the second cpu, everything is set to IP5, which is
* ignored, EXCEPT the mailbox interrupt. That one is
* set to IP[2] so it is handled. This is needed so we
* can do cross-cpu function calls, as required by SMP
*/
#define IMR_IP2_VAL K_INT_MAP_I0
#define IMR_IP3_VAL K_INT_MAP_I1
#define IMR_IP4_VAL K_INT_MAP_I2
#define IMR_IP5_VAL K_INT_MAP_I3
#define IMR_IP6_VAL K_INT_MAP_I4
void __init arch_init_irq(void)
{
unsigned int i;
u64 tmp;
unsigned int imask = STATUSF_IP4 | STATUSF_IP3 | STATUSF_IP2 |
STATUSF_IP1 | STATUSF_IP0;
/* Default everything to IP2 */
for (i = 0; i < SB1250_NR_IRQS; i++) { /* was I0 */
__raw_writeq(IMR_IP2_VAL,
IOADDR(A_IMR_REGISTER(0,
R_IMR_INTERRUPT_MAP_BASE) +
(i << 3)));
__raw_writeq(IMR_IP2_VAL,
IOADDR(A_IMR_REGISTER(1,
R_IMR_INTERRUPT_MAP_BASE) +
(i << 3)));
}
init_sb1250_irqs();
/*
* Map the high 16 bits of the mailbox registers to IP[3], for
* inter-cpu messages
*/
/* Was I1 */
__raw_writeq(IMR_IP3_VAL,
IOADDR(A_IMR_REGISTER(0, R_IMR_INTERRUPT_MAP_BASE) +
(K_INT_MBOX_0 << 3)));
__raw_writeq(IMR_IP3_VAL,
IOADDR(A_IMR_REGISTER(1, R_IMR_INTERRUPT_MAP_BASE) +
(K_INT_MBOX_0 << 3)));
/* Clear the mailboxes. The firmware may leave them dirty */
__raw_writeq(0xffffffffffffffffULL,
IOADDR(A_IMR_REGISTER(0, R_IMR_MAILBOX_CLR_CPU)));
__raw_writeq(0xffffffffffffffffULL,
IOADDR(A_IMR_REGISTER(1, R_IMR_MAILBOX_CLR_CPU)));
/* Mask everything except the mailbox registers for both cpus */
tmp = ~((u64) 0) ^ (((u64) 1) << K_INT_MBOX_0);
__raw_writeq(tmp, IOADDR(A_IMR_REGISTER(0, R_IMR_INTERRUPT_MASK)));
__raw_writeq(tmp, IOADDR(A_IMR_REGISTER(1, R_IMR_INTERRUPT_MASK)));
/* Enable necessary IPs, disable the rest */
change_c0_status(ST0_IM, imask);
}
extern void sb1250_mailbox_interrupt(void);
static inline void dispatch_ip2(void)
{
unsigned int cpu = smp_processor_id();
unsigned long long mask;
/*
* Default...we've hit an IP[2] interrupt, which means we've got to
* check the 1250 interrupt registers to figure out what to do. Need
* to detect which CPU we're on, now that smp_affinity is supported.
*/
mask = __raw_readq(IOADDR(A_IMR_REGISTER(cpu,
R_IMR_INTERRUPT_STATUS_BASE)));
if (mask)
do_IRQ(fls64(mask) - 1);
}
asmlinkage void plat_irq_dispatch(void)
{
unsigned int cpu = smp_processor_id();
unsigned int pending;
/*
* What a pain. We have to be really careful saving the upper 32 bits
* of any * register across function calls if we don't want them
* trashed--since were running in -o32, the calling routing never saves
* the full 64 bits of a register across a function call. Being the
* interrupt handler, we're guaranteed that interrupts are disabled
* during this code so we don't have to worry about random interrupts
* blasting the high 32 bits.
*/
pending = read_c0_cause() & read_c0_status() & ST0_IM;
if (pending & CAUSEF_IP7) /* CPU performance counter interrupt */
do_IRQ(MIPS_CPU_IRQ_BASE + 7);
else if (pending & CAUSEF_IP4)
do_IRQ(K_INT_TIMER_0 + cpu); /* sb1250_timer_interrupt() */
#ifdef CONFIG_SMP
else if (pending & CAUSEF_IP3)
sb1250_mailbox_interrupt();
#endif
else if (pending & CAUSEF_IP2)
dispatch_ip2();
else
spurious_interrupt();
}