Bindings for Voltage controlled regulators
==========================================

Required properties:
--------------------
- compatible		  : must be "vctrl-regulator".
- regulator-min-microvolt : smallest voltage consumers may set
- regulator-max-microvolt : largest voltage consumers may set
- ctrl-supply		  : The regulator supplying the control voltage.
- ctrl-voltage-range	  : an array of two integer values describing the range
			    (min/max) of the control voltage. The values specify
			    the control voltage needed to generate the corresponding
			    regulator-min/max-microvolt output voltage.

Optional properties:
--------------------
- ovp-threshold-percent	: overvoltage protection (OVP) threshold of the
			  regulator in percent. Some regulators have an OVP
			  circuitry which shuts down the regulator when the
			  actual output voltage deviates beyond a certain
			  margin from the expected value for a given control
			  voltage. On larger voltage decreases this can occur
			  undesiredly since the output voltage does not adjust
			  immediately to changes in the control voltage. To
			  avoid this situation the vctrl driver breaks down
			  larger voltage decreases into multiple steps, where
			  each step is within the OVP threshold.
- min-slew-down-rate	: Describes how slowly the regulator voltage will decay
			  down in the worst case (lightest expected load).
			  Specified in uV / us (like main regulator ramp rate).
			  This value is required when ovp-threshold-percent is
			  specified.

Example:

	vctrl-reg {
		compatible = "vctrl-regulator";
		regulator-name = "vctrl_reg";

		ctrl-supply = <&ctrl_reg>;

		regulator-min-microvolt = <800000>;
		regulator-max-microvolt = <1500000>;

		ctrl-voltage-range = <200000 500000>;

		min-slew-down-rate = <225>;
		ovp-threshold-percent = <16>;
	};