// SPDX-License-Identifier: GPL-2.0-or-later /* * Motion-PRO board Device Tree Source * * Copyright (C) 2007 Semihalf * Marian Balakowicz <m8@semihalf.com> */ /include/ "mpc5200b.dtsi" &gpt0 { fsl,has-wdt; }; &gpt6 { // Motion-PRO status LED compatible = "promess,motionpro-led"; label = "motionpro-statusled"; blink-delay = <100>; // 100 msec }; &gpt7 { // Motion-PRO ready LED compatible = "promess,motionpro-led"; label = "motionpro-readyled"; }; / { model = "promess,motionpro"; compatible = "promess,motionpro"; soc5200@f0000000 { can@900 { status = "disabled"; }; psc@2000 { // PSC1 compatible = "fsl,mpc5200b-psc-uart","fsl,mpc5200-psc-uart"; }; // PSC2 in spi master mode psc@2200 { // PSC2 compatible = "fsl,mpc5200b-psc-spi","fsl,mpc5200-psc-spi"; cell-index = <1>; }; psc@2400 { // PSC3 status = "disabled"; }; psc@2600 { // PSC4 status = "disabled"; }; psc@2800 { // PSC5 compatible = "fsl,mpc5200b-psc-uart","fsl,mpc5200-psc-uart"; }; psc@2c00 { // PSC6 status = "disabled"; }; ethernet@3000 { phy-handle = <&phy0>; }; mdio@3000 { phy0: ethernet-phy@2 { reg = <2>; }; }; i2c@3d00 { status = "disabled"; }; i2c@3d40 { rtc@68 { compatible = "dallas,ds1339"; reg = <0x68>; }; }; sram@8000 { compatible = "fsl,mpc5200b-sram","fsl,mpc5200-sram"; reg = <0x8000 0x4000>; }; }; pci@f0000d00 { status = "disabled"; }; localbus { ranges = <0 0 0xff000000 0x01000000 1 0 0x50000000 0x00010000 2 0 0x50010000 0x00010000 3 0 0x50020000 0x00010000>; // 8-bit DualPort SRAM on LocalPlus Bus CS1 kollmorgen@1,0 { compatible = "promess,motionpro-kollmorgen"; reg = <1 0 0x10000>; interrupts = <1 1 0>; }; // 8-bit board CPLD on LocalPlus Bus CS2 cpld@2,0 { compatible = "promess,motionpro-cpld"; reg = <2 0 0x10000>; }; // 8-bit custom Anybus Module on LocalPlus Bus CS3 anybus@3,0 { compatible = "promess,motionpro-anybus"; reg = <3 0 0x10000>; }; pro_module_general@3,0 { compatible = "promess,pro_module_general"; reg = <3 0 3>; }; pro_module_dio@3,800 { compatible = "promess,pro_module_dio"; reg = <3 0x800 2>; }; // 16-bit flash device at LocalPlus Bus CS0 flash@0,0 { compatible = "cfi-flash"; reg = <0 0 0x01000000>; bank-width = <2>; device-width = <2>; #size-cells = <1>; #address-cells = <1>; }; }; };