// SPDX-License-Identifier: (GPL-2.0+ OR BSD-3-Clause)
/*
 * Copyright (C) 2021 Marek Vasut
 */
#include <dt-bindings/gpio/gpio.h>

&{/} {
	panel {
		compatible = "powertip,ph800480t013-idf02";
		backlight = <&attiny>;
		power-supply = <&attiny>;

		port {
			panel_in: endpoint {
				remote-endpoint = <&bridge_out>;
			};
		};
	};
};

&attiny {
	compatible = "raspberrypi,7inch-touchscreen-panel-regulator";
	gpio-controller;
	#gpio-cells = <2>;
	reg = <0x45>;
};

&dsi {
	#address-cells = <1>;
	#size-cells = <0>;

	phy-dsi-supply = <&reg18>;
	status = "okay";

	bridge@0 {
		compatible = "toshiba,tc358762";
		reg = <0>;
		reset-gpios = <&attiny 0 GPIO_ACTIVE_HIGH>;
		vddc-supply = <&attiny>;
		status = "okay";

		ports {
			#address-cells = <1>;
			#size-cells = <0>;

			port@0 {
				reg = <0>;
				bridge_in: endpoint {
					remote-endpoint = <&dsi_out>;
				};
			};

			port@1 {
				reg = <1>;
				bridge_out: endpoint {
					remote-endpoint = <&panel_in>;
				};
			};
		};
	};

	ports {
		#address-cells = <1>;
		#size-cells = <0>;

		port@0 {
			reg = <0>;
			dsi_in: endpoint {
				remote-endpoint = <&ltdc_ep_out>;
			};
		};

		port@1 {
			reg = <1>;
			dsi_out: endpoint {
				remote-endpoint = <&bridge_in>;
			};
		};
	};
};

&touchscreen {
	compatible = "edt,edt-ft5406";
	reg = <0x38>;
	reset-gpios = <&attiny 1 GPIO_ACTIVE_LOW>;
	/*
	 * Disabled, since the IRQ line is not on
	 * the FPC cable, so we cannot get touch
	 * IRQs unless its connected otherwise. In
	 * that case, add entry like this one and
	 * enable below.
	 *
	 * interrupt-parent = <&gpiog>;
	 * interrupts = <2 IRQ_TYPE_EDGE_FALLING>;
	 */
	status = "disabled";
};