# SPDX-License-Identifier: GPL-2.0-only OR BSD-2-Clause
%YAML 1.2
---
$id: http://devicetree.org/schemas/mfd/rohm,bd72720-pmic.yaml#
$schema: http://devicetree.org/meta-schemas/core.yaml#
title: ROHM BD72720 and BD73900 Power Management Integrated Circuits
maintainers:
- Matti Vaittinen <mazziesaccount@gmail.com>
description:
BD72720 and BD73900 are single-chip power management ICs for
battery-powered portable devices. They integrate 10 bucks and 11 LDOs,
and a 3000 mA switching charger. ICs also include a Coulomb counter,
a real-time clock (RTC), GPIOs and a 32.768 kHz clock gate.
allOf:
- $ref: rohm,pmic-pins.yaml#
# In addition to the properties found from the charger node, PMICs
# use properties from a static battery node. Please see the:
# Documentation/devicetree/bindings/power/supply/battery.yaml
#
# Following properties are used
# when present:
#
# charge-full-design-microamp-hours: Battry capacity in mAh
# voltage-max-design-microvolt: Maximum voltage
# voltage-min-design-microvolt: Minimum voltage system is still operating.
# degrade-cycle-microamp-hours: Capacity lost due to aging at each full
# charge cycle.
# ocv-capacity-celsius: Array of OCV table temperatures. 1/table.
# ocv-capacity-table-<N>: Table of OCV voltage/SOC pairs. Corresponds
# N.th temperature in ocv-capacity-celsius
#
# volt-drop-thresh-microvolt: Threshold for starting the VDR correction
# volt-drop-soc: Table of capacity values matching the
# values in VDR tables.
#
# volt-drop-temperatures-millicelsius: Temperatures corresponding to the volage
# drop values given in volt-drop-[0-9]-microvolt
#
# volt-drop-[0-9]-microvolt: VDR table for a temperature specified in
# volt-drop-temperatures-millicelsius
#
# VDR tables are (usually) determined for a specific battery by ROHM.
# The battery node would then be referred from the charger node:
#
# monitored-battery = <&battery>;
properties:
compatible:
oneOf:
- const: rohm,bd72720
- items:
- const: rohm,bd73900
- const: rohm,bd72720
reg:
description:
I2C slave address.
maxItems: 1
interrupts:
maxItems: 1
gpio-controller: true
"#gpio-cells":
const: 2
description:
The first cell is the pin number and the second cell is used to specify
flags. See the gpio binding document for more information.
clocks:
maxItems: 1
"#clock-cells":
const: 0
clock-output-names:
const: bd71828-32k-out
rohm,clkout-open-drain: true
rohm,charger-sense-resistor-micro-ohms:
minimum: 10000
maximum: 50000
description:
PMIC has a SAR ADC for measuring charging currents. External sense
resistor (RSENSE in data sheet) should be used. If some other but
30 mOhm resistor is used the resistance value should be given here in
micro Ohms.
regulators:
$ref: /schemas/regulator/rohm,bd72720-regulator.yaml
description:
List of child nodes that specify the regulators.
leds:
$ref: /schemas/leds/rohm,bd71828-leds.yaml
rohm,pin-fault_b:
enum:
- faultb
- readyind
- gpo
- pwrseq
patternProperties:
"^rohm,pin-dvs[0-1]$":
enum:
- dvs-input
- gpi
- gpo
- pwrseq
"^rohm,pin-exten[0-1]$":
enum:
- gpo
- pwrseq
required:
- compatible
- reg
- interrupts
- clocks
- "#clock-cells"
- regulators
- gpio-controller
- "#gpio-cells"
additionalProperties: false
examples:
- |
#include <dt-bindings/interrupt-controller/irq.h>
#include <dt-bindings/leds/common.h>
i2c {
#address-cells = <1>;
#size-cells = <0>;
pmic: pmic@4b {
compatible = "rohm,bd72720";
reg = <0x4b>;
interrupt-parent = <&gpio1>;
interrupts = <29 IRQ_TYPE_LEVEL_LOW>;
clocks = <&osc 0>;
#clock-cells = <0>;
clock-output-names = "bd71828-32k-out";
gpio-controller;
#gpio-cells = <2>;
rohm,pin-dvs0 = "gpi";
rohm,pin-dvs1 = "gpi";
rohm,pin-exten0 = "gpo";
rohm,pin-exten1 = "gpo";
rohm,pin-fault_b = "faultb";
rohm,charger-sense-resistor-micro-ohms = <10000>;
regulators {
buck1 {
regulator-name = "buck1";
regulator-min-microvolt = <500000>;
regulator-max-microvolt = <2000000>;
regulator-ramp-delay = <2500>;
};
buck2 {
regulator-name = "buck2";
regulator-min-microvolt = <500000>;
regulator-max-microvolt = <2000000>;
regulator-ramp-delay = <2500>;
};
buck3 {
regulator-name = "buck3";
regulator-min-microvolt = <1200000>;
regulator-max-microvolt = <2000000>;
};
buck4 {
regulator-name = "buck4";
regulator-min-microvolt = <1000000>;
regulator-max-microvolt = <1800000>;
};
buck5 {
regulator-name = "buck5";
regulator-min-microvolt = <2500000>;
regulator-max-microvolt = <3300000>;
};
buck6 {
regulator-name = "buck6";
regulator-min-microvolt = <500000>;
regulator-max-microvolt = <2000000>;
regulator-ramp-delay = <2500>;
};
buck7 {
regulator-name = "buck7";
regulator-min-microvolt = <500000>;
regulator-max-microvolt = <2000000>;
regulator-ramp-delay = <2500>;
};
buck8 {
regulator-name = "buck8";
regulator-min-microvolt = <500000>;
regulator-max-microvolt = <1700000>;
regulator-ramp-delay = <2500>;
rohm,dvs-run-voltage = <1700000>;
rohm,dvs-idle-voltage = <1>;
rohm,dvs-suspend-voltage = <1>;
rohm,dvs-lpsr-voltage = <0>;
regulator-boot-on;
};
buck9 {
regulator-name = "buck9";
regulator-min-microvolt = <500000>;
regulator-max-microvolt = <1700000>;
regulator-ramp-delay = <2500>;
rohm,dvs-run-voltage = <1700000>;
rohm,dvs-idle-voltage = <1>;
rohm,dvs-suspend-voltage = <1>;
rohm,dvs-lpsr-voltage = <0>;
regulator-boot-on;
};
buck10 {
regulator-name = "buck10";
regulator-min-microvolt = <500000>;
regulator-max-microvolt = <1700000>;
regulator-ramp-delay = <2500>;
rohm,dvs-run-voltage = <1700000>;
rohm,dvs-idle-voltage = <1>;
rohm,dvs-suspend-voltage = <1>;
rohm,dvs-lpsr-voltage = <0>;
regulator-boot-on;
};
ldo1 {
regulator-name = "ldo1";
regulator-min-microvolt = <800000>;
regulator-max-microvolt = <3300000>;
};
ldo2 {
regulator-name = "ldo2";
regulator-min-microvolt = <800000>;
regulator-max-microvolt = <3300000>;
};
ldo3 {
regulator-name = "ldo3";
regulator-min-microvolt = <800000>;
regulator-max-microvolt = <3300000>;
};
ldo4 {
regulator-name = "ldo4";
regulator-min-microvolt = <800000>;
regulator-max-microvolt = <3300000>;
};
ldo5 {
regulator-name = "ldo5";
regulator-min-microvolt = <800000>;
regulator-max-microvolt = <3300000>;
};
ldo6 {
regulator-name = "ldo6";
regulator-min-microvolt = <1800000>;
regulator-max-microvolt = <1800000>;
};
ldo7 {
regulator-name = "ldo7";
regulator-min-microvolt = <800000>;
regulator-max-microvolt = <3300000>;
};
ldo8 {
regulator-name = "ldo8";
regulator-min-microvolt = <750000>;
regulator-max-microvolt = <3300000>;
rohm,dvs-suspend-voltage = <0>;
rohm,dvs-lpsr-voltage = <1>;
rohm,dvs-run-voltage = <750000>;
};
ldo9 {
regulator-name = "ldo9";
regulator-min-microvolt = <750000>;
regulator-max-microvolt = <3300000>;
rohm,dvs-suspend-voltage = <0>;
rohm,dvs-lpsr-voltage = <1>;
rohm,dvs-run-voltage = <750000>;
};
ldo10 {
regulator-name = "ldo10";
regulator-min-microvolt = <750000>;
regulator-max-microvolt = <3300000>;
rohm,dvs-suspend-voltage = <0>;
rohm,dvs-lpsr-voltage = <1>;
rohm,dvs-run-voltage = <750000>;
};
ldo11 {
regulator-name = "ldo11";
regulator-min-microvolt = <750000>;
regulator-max-microvolt = <3300000>;
rohm,dvs-suspend-voltage = <0>;
rohm,dvs-lpsr-voltage = <1>;
rohm,dvs-run-voltage = <750000>;
};
};
leds {
compatible = "rohm,bd71828-leds";
led-1 {
rohm,led-compatible = "bd71828-grnled";
function = LED_FUNCTION_INDICATOR;
color = <LED_COLOR_ID_GREEN>;
};
led-2 {
rohm,led-compatible = "bd71828-ambled";
function = LED_FUNCTION_CHARGING;
color = <LED_COLOR_ID_AMBER>;
};
};
};
};