// SPDX-License-Identifier: GPL-2.0-or-later OR MIT /* * Broadcom BCM470X / BCM5301X ARM platform code. * DTS for D-Link DIR-885L * * Copyright (C) 2016 Rafał Miłecki <zajec5@gmail.com> */ /dts-v1/; #include "bcm47094.dtsi" #include "bcm5301x-nand-cs0-bch1.dtsi" / { compatible = "dlink,dir-885l", "brcm,bcm47094", "brcm,bcm4708"; model = "D-Link DIR-885L"; chosen { bootargs = "console=ttyS0,115200 earlycon"; }; memory@0 { device_type = "memory"; reg = <0x00000000 0x08000000>, <0x88000000 0x08000000>; }; nand_controller: nand-controller@18028000 { nand@0 { partitions { compatible = "fixed-partitions"; #address-cells = <1>; #size-cells = <1>; partition@0 { compatible = "seama"; label = "firmware"; reg = <0x00000000 0x08000000>; }; }; }; }; leds { compatible = "gpio-leds"; led-power-white { label = "bcm53xx:white:power"; gpios = <&chipcommon 0 GPIO_ACTIVE_LOW>; linux,default-trigger = "default-on"; }; led-wan-white { label = "bcm53xx:white:wan"; gpios = <&chipcommon 1 GPIO_ACTIVE_LOW>; }; led-power-amber { label = "bcm53xx:amber:power"; gpios = <&chipcommon 2 GPIO_ACTIVE_LOW>; }; led-wan-amber { label = "bcm53xx:amber:wan"; gpios = <&chipcommon 3 GPIO_ACTIVE_LOW>; }; led-usb3-white { label = "bcm53xx:white:usb3"; gpios = <&chipcommon 8 GPIO_ACTIVE_LOW>; trigger-sources = <&ohci_port1>, <&ehci_port1>, <&xhci_port1>; linux,default-trigger = "usbport"; }; led-2ghz { label = "bcm53xx:white:2ghz"; gpios = <&chipcommon 13 GPIO_ACTIVE_LOW>; }; led-5ghz { label = "bcm53xx:white:5ghz"; gpios = <&chipcommon 14 GPIO_ACTIVE_LOW>; }; }; gpio-keys { compatible = "gpio-keys"; button-wps { label = "WPS"; linux,code = <KEY_WPS_BUTTON>; gpios = <&chipcommon 7 GPIO_ACTIVE_LOW>; }; /* Switch: router / extender */ button-extender { label = "Extender"; linux,code = <BTN_0>; gpios = <&chipcommon 10 GPIO_ACTIVE_LOW>; }; button-restart { label = "Reset"; linux,code = <KEY_RESTART>; gpios = <&chipcommon 17 GPIO_ACTIVE_LOW>; }; }; }; &usb3 { vcc-gpio = <&chipcommon 18 GPIO_ACTIVE_HIGH>; }; &spi_nor { status = "okay"; }; &usb3_phy { status = "okay"; }; &srab { status = "okay"; ports { port@0 { label = "lan4"; }; port@1 { label = "lan3"; }; port@2 { label = "lan2"; }; port@3 { label = "lan1"; }; port@4 { label = "wan"; }; port@8 { label = "cpu"; }; }; };