// SPDX-License-Identifier: GPL-2.0 /* * PCI operations for the Sega Dreamcast * * Copyright (C) 2001, 2002 M. R. Brown * Copyright (C) 2002, 2003 Paul Mundt */ #include <linux/sched.h> #include <linux/kernel.h> #include <linux/param.h> #include <linux/interrupt.h> #include <linux/init.h> #include <linux/irq.h> #include <linux/pci.h> #include <linux/module.h> #include <linux/io.h> #include <mach/pci.h> /* * The !gapspci_config_access case really shouldn't happen, ever, unless * someone implicitly messes around with the last devfn value.. otherwise we * only support a single device anyways, and if we didn't have a BBA, we * wouldn't make it terribly far through the PCI setup anyways. * * Also, we could very easily support both Type 0 and Type 1 configurations * here, but since it doesn't seem that there is any such implementation in * existence, we don't bother. * * I suppose if someone actually gets around to ripping the chip out of * the BBA and hanging some more devices off of it, then this might be * something to take into consideration. However, due to the cost of the BBA, * and the general lack of activity by DC hardware hackers, this doesn't seem * likely to happen anytime soon. */ static int gapspci_config_access(unsigned char bus, unsigned int devfn) { return (bus == 0) && (devfn == 0); } /* * We can also actually read and write in b/w/l sizes! Thankfully this part * was at least done right, and we don't have to do the stupid masking and * shifting that we do on the 7751! Small wonders never cease to amaze. */ static int gapspci_read(struct pci_bus *bus, unsigned int devfn, int where, int size, u32 *val) { *val = 0xffffffff; if (!gapspci_config_access(bus->number, devfn)) return PCIBIOS_DEVICE_NOT_FOUND; switch (size) { case 1: *val = inb(GAPSPCI_BBA_CONFIG+where); break; case 2: *val = inw(GAPSPCI_BBA_CONFIG+where); break; case 4: *val = inl(GAPSPCI_BBA_CONFIG+where); break; } return PCIBIOS_SUCCESSFUL; } static int gapspci_write(struct pci_bus *bus, unsigned int devfn, int where, int size, u32 val) { if (!gapspci_config_access(bus->number, devfn)) return PCIBIOS_DEVICE_NOT_FOUND; switch (size) { case 1: outb(( u8)val, GAPSPCI_BBA_CONFIG+where); break; case 2: outw((u16)val, GAPSPCI_BBA_CONFIG+where); break; case 4: outl((u32)val, GAPSPCI_BBA_CONFIG+where); break; } return PCIBIOS_SUCCESSFUL; } struct pci_ops gapspci_pci_ops = { .read = gapspci_read, .write = gapspci_write, };