Synopsys DesignWare APB interrupt controller (dw_apb_ictl)

Synopsys DesignWare provides interrupt controller IP for APB known as
dw_apb_ictl. The IP is used as secondary interrupt controller in some SoCs with
APB bus, e.g. Marvell Armada 1500. It can also be used as primary interrupt
controller in some SoCs, e.g. Hisilicon SD5203.

Required properties:
- compatible: shall be "snps,dw-apb-ictl"
- reg: physical base address of the controller and length of memory mapped
  region starting with ENABLE_LOW register
- interrupt-controller: identifies the node as an interrupt controller
- #interrupt-cells: number of cells to encode an interrupt-specifier, shall be 1

Additional required property when it's used as secondary interrupt controller:
- interrupts: interrupt reference to primary interrupt controller

The interrupt sources map to the corresponding bits in the interrupt
registers, i.e.
- 0 maps to bit 0 of low interrupts,
- 1 maps to bit 1 of low interrupts,
- 32 maps to bit 0 of high interrupts,
- 33 maps to bit 1 of high interrupts,
- (optional) fast interrupts start at 64.

Example:
	/* dw_apb_ictl is used as secondary interrupt controller */
	aic: interrupt-controller@3000 {
		compatible = "snps,dw-apb-ictl";
		reg = <0x3000 0xc00>;
		interrupt-controller;
		#interrupt-cells = <1>;
		interrupt-parent = <&gic>;
		interrupts = <GIC_SPI 3 IRQ_TYPE_LEVEL_HIGH>;
	};

	/* dw_apb_ictl is used as primary interrupt controller */
	vic: interrupt-controller@10130000 {
		compatible = "snps,dw-apb-ictl";
		reg = <0x10130000 0x1000>;
		interrupt-controller;
		#interrupt-cells = <1>;
	};