// SPDX-License-Identifier: GPL-2.0 #include <dt-bindings/iio/qcom,spmi-vadc.h> #include <dt-bindings/input/linux-event-codes.h> #include <dt-bindings/interrupt-controller/irq.h> #include <dt-bindings/spmi/spmi.h> &spmi_bus { pm8916_0: pmic@0 { compatible = "qcom,pm8916", "qcom,spmi-pmic"; reg = <0x0 SPMI_USID>; #address-cells = <1>; #size-cells = <0>; pon@800 { compatible = "qcom,pm8916-pon"; reg = <0x800>; mode-bootloader = <0x2>; mode-recovery = <0x1>; pwrkey { compatible = "qcom,pm8941-pwrkey"; interrupts = <0x0 0x8 0 IRQ_TYPE_EDGE_BOTH>; debounce = <15625>; bias-pull-up; linux,code = <KEY_POWER>; }; pm8916_resin: resin { compatible = "qcom,pm8941-resin"; interrupts = <0x0 0x8 1 IRQ_TYPE_EDGE_BOTH>; debounce = <15625>; bias-pull-up; status = "disabled"; }; watchdog { compatible = "qcom,pm8916-wdt"; interrupts = <0x0 0x8 6 IRQ_TYPE_EDGE_RISING>; timeout-sec = <60>; }; }; pm8916_usbin: usb-detect@1300 { compatible = "qcom,pm8941-misc"; reg = <0x1300>; interrupts = <0x0 0x13 1 IRQ_TYPE_EDGE_BOTH>; interrupt-names = "usb_vbus"; status = "disabled"; }; pm8916_temp: temp-alarm@2400 { compatible = "qcom,spmi-temp-alarm"; reg = <0x2400>; interrupts = <0 0x24 0 IRQ_TYPE_EDGE_RISING>; io-channels = <&pm8916_vadc VADC_DIE_TEMP>; io-channel-names = "thermal"; #thermal-sensor-cells = <0>; }; pm8916_vadc: adc@3100 { compatible = "qcom,spmi-vadc"; reg = <0x3100>; interrupts = <0x0 0x31 0x0 IRQ_TYPE_EDGE_RISING>; #address-cells = <1>; #size-cells = <0>; #io-channel-cells = <1>; channel@0 { reg = <VADC_USBIN>; qcom,pre-scaling = <1 10>; }; channel@7 { reg = <VADC_VSYS>; qcom,pre-scaling = <1 3>; }; channel@8 { reg = <VADC_DIE_TEMP>; }; channel@9 { reg = <VADC_REF_625MV>; }; channel@a { reg = <VADC_REF_1250MV>; }; channel@e { reg = <VADC_GND_REF>; }; channel@f { reg = <VADC_VDD_VADC>; }; }; rtc@6000 { compatible = "qcom,pm8941-rtc"; reg = <0x6000>, <0x6100>; reg-names = "rtc", "alarm"; interrupts = <0x0 0x61 0x1 IRQ_TYPE_EDGE_RISING>; }; pm8916_mpps: mpps@a000 { compatible = "qcom,pm8916-mpp", "qcom,spmi-mpp"; reg = <0xa000>; gpio-controller; #gpio-cells = <2>; gpio-ranges = <&pm8916_mpps 0 0 4>; interrupt-controller; #interrupt-cells = <2>; }; pm8916_gpios: gpio@c000 { compatible = "qcom,pm8916-gpio", "qcom,spmi-gpio"; reg = <0xc000>; gpio-controller; gpio-ranges = <&pm8916_gpios 0 0 4>; #gpio-cells = <2>; interrupt-controller; #interrupt-cells = <2>; }; }; pm8916_1: pmic@1 { compatible = "qcom,pm8916", "qcom,spmi-pmic"; reg = <0x1 SPMI_USID>; #address-cells = <1>; #size-cells = <0>; pm8916_pwm: pwm { compatible = "qcom,pm8916-pwm"; #pwm-cells = <2>; status = "disabled"; }; pm8916_vib: vibrator@c000 { compatible = "qcom,pm8916-vib"; reg = <0xc000>; status = "disabled"; }; pm8916_codec: audio-codec@f000 { compatible = "qcom,pm8916-wcd-analog-codec"; reg = <0xf000>; reg-names = "pmic-codec-core"; clocks = <&gcc GCC_CODEC_DIGCODEC_CLK>; clock-names = "mclk"; interrupt-parent = <&spmi_bus>; interrupts = <0x1 0xf0 0x0 IRQ_TYPE_NONE>, <0x1 0xf0 0x1 IRQ_TYPE_NONE>, <0x1 0xf0 0x2 IRQ_TYPE_NONE>, <0x1 0xf0 0x3 IRQ_TYPE_NONE>, <0x1 0xf0 0x4 IRQ_TYPE_NONE>, <0x1 0xf0 0x5 IRQ_TYPE_NONE>, <0x1 0xf0 0x6 IRQ_TYPE_NONE>, <0x1 0xf0 0x7 IRQ_TYPE_NONE>, <0x1 0xf1 0x0 IRQ_TYPE_NONE>, <0x1 0xf1 0x1 IRQ_TYPE_NONE>, <0x1 0xf1 0x2 IRQ_TYPE_NONE>, <0x1 0xf1 0x3 IRQ_TYPE_NONE>, <0x1 0xf1 0x4 IRQ_TYPE_NONE>, <0x1 0xf1 0x5 IRQ_TYPE_NONE>; interrupt-names = "cdc_spk_cnp_int", "cdc_spk_clip_int", "cdc_spk_ocp_int", "mbhc_ins_rem_det1", "mbhc_but_rel_det", "mbhc_but_press_det", "mbhc_ins_rem_det", "mbhc_switch_int", "cdc_ear_ocp_int", "cdc_hphr_ocp_int", "cdc_hphl_ocp_det", "cdc_ear_cnp_int", "cdc_hphr_cnp_int", "cdc_hphl_cnp_int"; #sound-dai-cells = <1>; status = "disabled"; }; }; };