// SPDX-License-Identifier: GPL-2.0-only /dts-v1/; #include "dm814x.dtsi" #include <dt-bindings/interrupt-controller/irq.h> / { model = "DM8148 EVM"; compatible = "ti,dm8148-evm", "ti,dm8148", "ti,dm814"; memory@80000000 { device_type = "memory"; reg = <0x80000000 0x40000000>; /* 1 GB */ }; /* MIC94060YC6 controlled by SD1_POW pin */ vmmcsd_fixed: fixedregulator0 { compatible = "regulator-fixed"; regulator-name = "vmmcsd_fixed"; regulator-min-microvolt = <3300000>; regulator-max-microvolt = <3300000>; }; }; &cpsw_emac0 { phy-handle = <ðphy0>; phy-mode = "rgmii-id"; }; &cpsw_emac1 { phy-handle = <ðphy1>; phy-mode = "rgmii-id"; }; &davinci_mdio { ethphy0: ethernet-phy@0 { reg = <0>; }; ethphy1: ethernet-phy@1 { reg = <1>; }; }; &gpmc { ranges = <0 0 0x04000000 0x01000000>; /* CS0: 16MB for NAND */ nand@0,0 { compatible = "ti,omap2-nand"; reg = <0 0 4>; /* CS0, offset 0, IO size 4 */ interrupt-parent = <&gpmc>; interrupts = <0 IRQ_TYPE_NONE>, /* fifoevent */ <1 IRQ_TYPE_NONE>; /* termcount */ linux,mtd-name = "micron,mt29f2g16aadwp"; #address-cells = <1>; #size-cells = <1>; ti,nand-ecc-opt = "bch8"; nand-bus-width = <16>; gpmc,device-width = <2>; gpmc,sync-clk-ps = <0>; gpmc,cs-on-ns = <0>; gpmc,cs-rd-off-ns = <44>; gpmc,cs-wr-off-ns = <44>; gpmc,adv-on-ns = <6>; gpmc,adv-rd-off-ns = <34>; gpmc,adv-wr-off-ns = <44>; gpmc,we-on-ns = <0>; gpmc,we-off-ns = <40>; gpmc,oe-on-ns = <0>; gpmc,oe-off-ns = <54>; gpmc,access-ns = <64>; gpmc,rd-cycle-ns = <82>; gpmc,wr-cycle-ns = <82>; gpmc,bus-turnaround-ns = <0>; gpmc,cycle2cycle-delay-ns = <0>; gpmc,clk-activation-ns = <0>; gpmc,wr-access-ns = <40>; gpmc,wr-data-mux-bus-ns = <0>; partition@0 { label = "X-Loader"; reg = <0 0x80000>; }; partition@80000 { label = "U-Boot"; reg = <0x80000 0x1c0000>; }; partition@1c0000 { label = "Environment"; reg = <0x240000 0x40000>; }; partition@280000 { label = "Kernel"; reg = <0x280000 0x500000>; }; partition@780000 { label = "Filesystem"; reg = <0x780000 0xf880000>; }; }; }; &mmc1 { status = "disabled"; }; &mmc2 { pinctrl-names = "default"; pinctrl-0 = <&sd1_pins>; vmmc-supply = <&vmmcsd_fixed>; bus-width = <4>; cd-gpios = <&gpio2 6 GPIO_ACTIVE_LOW>; }; &mmc3 { status = "disabled"; }; &pincntl { sd1_pins: sd1-pins { pinctrl-single,pins = < DM814X_IOPAD(0x0800, PIN_INPUT | 0x1) /* SD1_CLK */ DM814X_IOPAD(0x0804, PIN_INPUT_PULLUP | 0x1) /* SD1_CMD */ DM814X_IOPAD(0x0808, PIN_INPUT_PULLUP | 0x1) /* SD1_DAT[0] */ DM814X_IOPAD(0x080c, PIN_INPUT_PULLUP | 0x1) /* SD1_DAT[1] */ DM814X_IOPAD(0x0810, PIN_INPUT_PULLUP | 0x1) /* SD1_DAT[2] */ DM814X_IOPAD(0x0814, PIN_INPUT_PULLUP | 0x1) /* SD1_DAT[3] */ DM814X_IOPAD(0x0924, PIN_OUTPUT | 0x40) /* SD1_POW */ DM814X_IOPAD(0x093C, PIN_INPUT_PULLUP | 0x80) /* GP1[6] */ >; }; usb0_pins: usb0-pins { pinctrl-single,pins = < DM814X_IOPAD(0x0c34, PIN_OUTPUT | 0x1) /* USB0_DRVVBUS */ >; }; usb1_pins: usb1-pins { pinctrl-single,pins = < DM814X_IOPAD(0x0834, PIN_OUTPUT | 0x80) /* USB1_DRVVBUS */ >; }; }; &usb0 { pinctrl-names = "default"; pinctrl-0 = <&usb0_pins>; dr_mode = "host"; }; &usb1 { pinctrl-names = "default"; pinctrl-0 = <&usb1_pins>; dr_mode = "host"; };