// SPDX-License-Identifier: GPL-2.0-or-later OR MIT /* * Author: Arınç ÜNAL <arinc.unal@arinc9.com> */ #include "bcm47094.dtsi" #include "bcm5301x-nand-cs0-bch8.dtsi" / { chosen { bootargs = "earlycon"; }; memory@0 { device_type = "memory"; reg = <0x00000000 0x08000000>, <0x88000000 0x18000000>; }; nvram@1c080000 { compatible = "brcm,nvram"; reg = <0x1c080000 0x00180000>; }; leds { compatible = "gpio-leds"; led-power { label = "white:power"; gpios = <&chipcommon 3 GPIO_ACTIVE_LOW>; linux,default-trigger = "default-on"; }; led-wan-red { label = "red:wan"; gpios = <&chipcommon 5 GPIO_ACTIVE_HIGH>; }; led-lan { label = "white:lan"; gpios = <&chipcommon 21 GPIO_ACTIVE_LOW>; }; led-usb2 { label = "white:usb2"; gpios = <&chipcommon 16 GPIO_ACTIVE_LOW>; trigger-sources = <&ehci_port2>; linux,default-trigger = "usbport"; }; led-usb3 { label = "white:usb3"; gpios = <&chipcommon 17 GPIO_ACTIVE_LOW>; trigger-sources = <&ehci_port1>, <&xhci_port1>; linux,default-trigger = "usbport"; }; led-wps { label = "white:wps"; gpios = <&chipcommon 19 GPIO_ACTIVE_LOW>; }; }; gpio-keys { compatible = "gpio-keys"; button-wps { label = "WPS"; linux,code = <KEY_WPS_BUTTON>; gpios = <&chipcommon 20 GPIO_ACTIVE_LOW>; }; button-reset { label = "Reset"; linux,code = <KEY_RESTART>; gpios = <&chipcommon 11 GPIO_ACTIVE_LOW>; }; button-wifi { label = "Wi-Fi"; linux,code = <KEY_RFKILL>; gpios = <&chipcommon 18 GPIO_ACTIVE_LOW>; }; button-led { label = "Backlight"; linux,code = <KEY_BRIGHTNESS_ZERO>; gpios = <&chipcommon 4 GPIO_ACTIVE_LOW>; }; }; }; &srab { compatible = "brcm,bcm53012-srab", "brcm,bcm5301x-srab"; status = "okay"; ports { port@0 { label = "lan4"; }; port@1 { label = "lan3"; }; port@2 { label = "lan2"; }; port@3 { label = "lan1"; }; port@4 { label = "wan"; }; port@5 { label = "cpu"; }; port@7 { label = "cpu"; }; port@8 { label = "cpu"; }; }; }; &usb2 { vcc-gpio = <&chipcommon 9 GPIO_ACTIVE_HIGH>; }; &usb3_phy { status = "okay"; }; &nandcs { partitions { compatible = "fixed-partitions"; #address-cells = <1>; #size-cells = <1>; partition@0 { label = "boot"; reg = <0x00000000 0x00080000>; read-only; }; partition@80000 { label = "nvram"; reg = <0x00080000 0x00180000>; }; partition@200000 { label = "firmware"; reg = <0x00200000 0x07e00000>; compatible = "brcm,trx"; }; }; };