/*
* Hardware definitions for TI OMAP processors and boards
*
* NOTE: Please put device driver specific defines into a separate header
* file for each driver.
*
* Copyright (C) 2001 RidgeRun, Inc.
* Author: RidgeRun, Inc. Greg Lonnon <glonnon@ridgerun.com>
*
* Reorganized for Linux-2.6 by Tony Lindgren <tony@atomide.com>
* and Dirk Behme <dirk.behme@de.bosch.com>
*
* This program is free software; you can redistribute it and/or modify it
* under the terms of the GNU General Public License as published by the
* Free Software Foundation; either version 2 of the License, or (at your
* option) any later version.
*
* THIS SOFTWARE IS PROVIDED ``AS IS'' AND ANY EXPRESS OR IMPLIED
* WARRANTIES, INCLUDING, BUT NOT LIMITED TO, THE IMPLIED WARRANTIES OF
* MERCHANTABILITY AND FITNESS FOR A PARTICULAR PURPOSE ARE DISCLAIMED. IN
* NO EVENT SHALL THE AUTHOR BE LIABLE FOR ANY DIRECT, INDIRECT,
* INCIDENTAL, SPECIAL, EXEMPLARY, OR CONSEQUENTIAL DAMAGES (INCLUDING, BUT
* NOT LIMITED TO, PROCUREMENT OF SUBSTITUTE GOODS OR SERVICES; LOSS OF
* USE, DATA, OR PROFITS; OR BUSINESS INTERRUPTION) HOWEVER CAUSED AND ON
* ANY THEORY OF LIABILITY, WHETHER IN CONTRACT, STRICT LIABILITY, OR TORT
* (INCLUDING NEGLIGENCE OR OTHERWISE) ARISING IN ANY WAY OUT OF THE USE OF
* THIS SOFTWARE, EVEN IF ADVISED OF THE POSSIBILITY OF SUCH DAMAGE.
*
* You should have received a copy of the GNU General Public License along
* with this program; if not, write to the Free Software Foundation, Inc.,
* 675 Mass Ave, Cambridge, MA 02139, USA.
*/
#ifndef __ASM_ARCH_OMAP_HARDWARE_H
#define __ASM_ARCH_OMAP_HARDWARE_H
#include <linux/sizes.h>
#include <linux/soc/ti/omap1-io.h>
#ifndef __ASSEMBLER__
#include <asm/types.h>
#include <linux/soc/ti/omap1-soc.h>
#include "tc.h"
/* Almost all documentation for chip and board memory maps assumes
* BM is clear. Most devel boards have a switch to control booting
* from NOR flash (using external chipselect 3) rather than mask ROM,
* which uses BM to interchange the physical CS0 and CS3 addresses.
*/
static inline u32 omap_cs0m_phys(void)
{
return (omap_readl(EMIFS_CONFIG) & OMAP_EMIFS_CONFIG_BM)
? OMAP_CS3_PHYS : 0;
}
static inline u32 omap_cs3_phys(void)
{
return (omap_readl(EMIFS_CONFIG) & OMAP_EMIFS_CONFIG_BM)
? 0 : OMAP_CS3_PHYS;
}
#endif /* ifndef __ASSEMBLER__ */
#define OMAP1_IO_OFFSET 0x00f00000 /* Virtual IO = 0xff0b0000 */
#define OMAP1_IO_ADDRESS(pa) IOMEM((pa) - OMAP1_IO_OFFSET)
#include "serial.h"
/*
* ---------------------------------------------------------------------------
* Common definitions for all OMAP processors
* NOTE: Put all processor or board specific parts to the special header
* files.
* ---------------------------------------------------------------------------
*/
/*
* ----------------------------------------------------------------------------
* Timers
* ----------------------------------------------------------------------------
*/
#define OMAP_MPU_TIMER1_BASE (0xfffec500)
#define OMAP_MPU_TIMER2_BASE (0xfffec600)
#define OMAP_MPU_TIMER3_BASE (0xfffec700)
#define MPU_TIMER_FREE (1 << 6)
#define MPU_TIMER_CLOCK_ENABLE (1 << 5)
#define MPU_TIMER_AR (1 << 1)
#define MPU_TIMER_ST (1 << 0)
/*
* ---------------------------------------------------------------------------
* Watchdog timer
* ---------------------------------------------------------------------------
*/
/* Watchdog timer within the OMAP3.2 gigacell */
#define OMAP_MPU_WATCHDOG_BASE (0xfffec800)
#define OMAP_WDT_TIMER (OMAP_MPU_WATCHDOG_BASE + 0x0)
#define OMAP_WDT_LOAD_TIM (OMAP_MPU_WATCHDOG_BASE + 0x4)
#define OMAP_WDT_READ_TIM (OMAP_MPU_WATCHDOG_BASE + 0x4)
#define OMAP_WDT_TIMER_MODE (OMAP_MPU_WATCHDOG_BASE + 0x8)
/*
* ---------------------------------------------------------------------------
* Interrupts
* ---------------------------------------------------------------------------
*/
#ifdef CONFIG_ARCH_OMAP1
/*
* XXX: These probably want to be moved to arch/arm/mach-omap/omap1/irq.c
* or something similar.. -- PFM.
*/
#define OMAP_IH1_BASE 0xfffecb00
#define OMAP_IH2_BASE 0xfffe0000
#define OMAP_IH2_0_BASE (0xfffe0000)
#define OMAP_IH2_1_BASE (0xfffe0100)
#define OMAP_IH2_2_BASE (0xfffe0200)
#define OMAP_IH2_3_BASE (0xfffe0300)
#define OMAP_IH1_ITR (OMAP_IH1_BASE + 0x00)
#define OMAP_IH1_MIR (OMAP_IH1_BASE + 0x04)
#define OMAP_IH1_SIR_IRQ (OMAP_IH1_BASE + 0x10)
#define OMAP_IH1_SIR_FIQ (OMAP_IH1_BASE + 0x14)
#define OMAP_IH1_CONTROL (OMAP_IH1_BASE + 0x18)
#define OMAP_IH1_ILR0 (OMAP_IH1_BASE + 0x1c)
#define OMAP_IH1_ISR (OMAP_IH1_BASE + 0x9c)
#define OMAP_IH2_ITR (OMAP_IH2_BASE + 0x00)
#define OMAP_IH2_MIR (OMAP_IH2_BASE + 0x04)
#define OMAP_IH2_SIR_IRQ (OMAP_IH2_BASE + 0x10)
#define OMAP_IH2_SIR_FIQ (OMAP_IH2_BASE + 0x14)
#define OMAP_IH2_CONTROL (OMAP_IH2_BASE + 0x18)
#define OMAP_IH2_ILR0 (OMAP_IH2_BASE + 0x1c)
#define OMAP_IH2_ISR (OMAP_IH2_BASE + 0x9c)
#define OMAP_IH2_0_ITR (OMAP_IH2_0_BASE + 0x00)
#define OMAP_IH2_0_MIR (OMAP_IH2_0_BASE + 0x04)
#define OMAP_IH2_0_SIR_IRQ (OMAP_IH2_0_BASE + 0x10)
#define OMAP_IH2_0_SIR_FIQ (OMAP_IH2_0_BASE + 0x14)
#define OMAP_IH2_0_CONTROL (OMAP_IH2_0_BASE + 0x18)
#define OMAP_IH2_0_ILR0 (OMAP_IH2_0_BASE + 0x1c)
#define OMAP_IH2_0_ISR (OMAP_IH2_0_BASE + 0x9c)
#define OMAP_IH2_1_ITR (OMAP_IH2_1_BASE + 0x00)
#define OMAP_IH2_1_MIR (OMAP_IH2_1_BASE + 0x04)
#define OMAP_IH2_1_SIR_IRQ (OMAP_IH2_1_BASE + 0x10)
#define OMAP_IH2_1_SIR_FIQ (OMAP_IH2_1_BASE + 0x14)
#define OMAP_IH2_1_CONTROL (OMAP_IH2_1_BASE + 0x18)
#define OMAP_IH2_1_ILR1 (OMAP_IH2_1_BASE + 0x1c)
#define OMAP_IH2_1_ISR (OMAP_IH2_1_BASE + 0x9c)
#define OMAP_IH2_2_ITR (OMAP_IH2_2_BASE + 0x00)
#define OMAP_IH2_2_MIR (OMAP_IH2_2_BASE + 0x04)
#define OMAP_IH2_2_SIR_IRQ (OMAP_IH2_2_BASE + 0x10)
#define OMAP_IH2_2_SIR_FIQ (OMAP_IH2_2_BASE + 0x14)
#define OMAP_IH2_2_CONTROL (OMAP_IH2_2_BASE + 0x18)
#define OMAP_IH2_2_ILR2 (OMAP_IH2_2_BASE + 0x1c)
#define OMAP_IH2_2_ISR (OMAP_IH2_2_BASE + 0x9c)
#define OMAP_IH2_3_ITR (OMAP_IH2_3_BASE + 0x00)
#define OMAP_IH2_3_MIR (OMAP_IH2_3_BASE + 0x04)
#define OMAP_IH2_3_SIR_IRQ (OMAP_IH2_3_BASE + 0x10)
#define OMAP_IH2_3_SIR_FIQ (OMAP_IH2_3_BASE + 0x14)
#define OMAP_IH2_3_CONTROL (OMAP_IH2_3_BASE + 0x18)
#define OMAP_IH2_3_ILR3 (OMAP_IH2_3_BASE + 0x1c)
#define OMAP_IH2_3_ISR (OMAP_IH2_3_BASE + 0x9c)
#define IRQ_ITR_REG_OFFSET 0x00
#define IRQ_MIR_REG_OFFSET 0x04
#define IRQ_SIR_IRQ_REG_OFFSET 0x10
#define IRQ_SIR_FIQ_REG_OFFSET 0x14
#define IRQ_CONTROL_REG_OFFSET 0x18
#define IRQ_ISR_REG_OFFSET 0x9c
#define IRQ_ILR0_REG_OFFSET 0x1c
#define IRQ_GMR_REG_OFFSET 0xa0
#endif
/* Timer32K for 1610 and 1710*/
#define OMAP_TIMER32K_BASE 0xFFFBC400
/*
* ---------------------------------------------------------------------------
* TIPB bus interface
* ---------------------------------------------------------------------------
*/
#define TIPB_PUBLIC_CNTL_BASE 0xfffed300
#define MPU_PUBLIC_TIPB_CNTL (TIPB_PUBLIC_CNTL_BASE + 0x8)
#define TIPB_PRIVATE_CNTL_BASE 0xfffeca00
#define MPU_PRIVATE_TIPB_CNTL (TIPB_PRIVATE_CNTL_BASE + 0x8)
/*
* ----------------------------------------------------------------------------
* MPUI interface
* ----------------------------------------------------------------------------
*/
#define MPUI_BASE (0xfffec900)
#define MPUI_CTRL (MPUI_BASE + 0x0)
#define MPUI_DEBUG_ADDR (MPUI_BASE + 0x4)
#define MPUI_DEBUG_DATA (MPUI_BASE + 0x8)
#define MPUI_DEBUG_FLAG (MPUI_BASE + 0xc)
#define MPUI_STATUS_REG (MPUI_BASE + 0x10)
#define MPUI_DSP_STATUS (MPUI_BASE + 0x14)
#define MPUI_DSP_BOOT_CONFIG (MPUI_BASE + 0x18)
#define MPUI_DSP_API_CONFIG (MPUI_BASE + 0x1c)
/*
* ----------------------------------------------------------------------------
* LED Pulse Generator
* ----------------------------------------------------------------------------
*/
#define OMAP_LPG1_BASE 0xfffbd000
#define OMAP_LPG2_BASE 0xfffbd800
#define OMAP_LPG1_LCR (OMAP_LPG1_BASE + 0x00)
#define OMAP_LPG1_PMR (OMAP_LPG1_BASE + 0x04)
#define OMAP_LPG2_LCR (OMAP_LPG2_BASE + 0x00)
#define OMAP_LPG2_PMR (OMAP_LPG2_BASE + 0x04)
/*
* ---------------------------------------------------------------------------
* DSP
* ---------------------------------------------------------------------------
*/
#define OMAP1_DSP_BASE 0xE0000000
#define OMAP1_DSP_SIZE 0x28000
#define OMAP1_DSP_START 0xE0000000
#define OMAP1_DSPREG_BASE 0xE1000000
#define OMAP1_DSPREG_SIZE SZ_128K
#define OMAP1_DSPREG_START 0xE1000000
#endif /* __ASM_ARCH_OMAP_HARDWARE_H */