// SPDX-License-Identifier: GPL-2.0 /** * DT Overlay for CPSW5G in QSGMII mode using J7 Quad Port ETH EXP Add-On Ethernet Card with * J7200 board. * * Copyright (C) 2023 Texas Instruments Incorporated - https://www.ti.com/ */ /dts-v1/; /plugin/; #include <dt-bindings/gpio/gpio.h> #include "k3-pinctrl.h" #include "k3-serdes.h" &{/} { aliases { ethernet1 = "/bus@100000/ethernet@c000000/ethernet-ports/port@1"; ethernet2 = "/bus@100000/ethernet@c000000/ethernet-ports/port@2"; ethernet3 = "/bus@100000/ethernet@c000000/ethernet-ports/port@3"; ethernet4 = "/bus@100000/ethernet@c000000/ethernet-ports/port@4"; }; }; &cpsw0 { status = "okay"; }; &cpsw0_port1 { status = "okay"; phy-handle = <&cpsw5g_phy0>; phy-mode = "qsgmii"; mac-address = [00 00 00 00 00 00]; phys = <&cpsw0_phy_gmii_sel 1>; }; &cpsw0_port2 { status = "okay"; phy-handle = <&cpsw5g_phy1>; phy-mode = "qsgmii"; mac-address = [00 00 00 00 00 00]; phys = <&cpsw0_phy_gmii_sel 2>; }; &cpsw0_port3 { status = "okay"; phy-handle = <&cpsw5g_phy2>; phy-mode = "qsgmii"; mac-address = [00 00 00 00 00 00]; phys = <&cpsw0_phy_gmii_sel 3>; }; &cpsw0_port4 { status = "okay"; phy-handle = <&cpsw5g_phy3>; phy-mode = "qsgmii"; mac-address = [00 00 00 00 00 00]; phys = <&cpsw0_phy_gmii_sel 4>; }; &cpsw5g_mdio { status = "okay"; pinctrl-names = "default"; pinctrl-0 = <&mdio0_pins_default>; reset-gpios = <&exp2 17 GPIO_ACTIVE_LOW>; reset-post-delay-us = <120000>; #address-cells = <1>; #size-cells = <0>; cpsw5g_phy0: ethernet-phy@16 { reg = <16>; }; cpsw5g_phy1: ethernet-phy@17 { reg = <17>; }; cpsw5g_phy2: ethernet-phy@18 { reg = <18>; }; cpsw5g_phy3: ethernet-phy@19 { reg = <19>; }; }; &exp2 { qsgmii-line-hog { gpio-hog; gpios = <16 GPIO_ACTIVE_HIGH>; output-low; line-name = "qsgmii-pwrdn-line"; }; }; &main_pmx0 { mdio0_pins_default: mdio0-default-pins { pinctrl-single,pins = < J721E_IOPAD(0x00a8, PIN_OUTPUT, 5) /* (W19) UART8_TXD.MDIO0_MDC */ J721E_IOPAD(0x00a4, PIN_INPUT, 5) /* (W14) UART8_RXD.MDIO0_MDIO */ >; }; };